15
Parental Control -- Select a connected device to add to Limited Device List, you can also set the
days and times to limit data access.
Settings -- customize your device's Wi-Fi and security settings (See
Device Configuration
on page
28).
Run Device Diagnostics-- Diagnosis the device basic status: network, Wi-Fi and firewall.
About Your Device -- get details regarding current device status and information.
AT&T Software Update -- view software updates that are delivered automatically over the AT&T
cellular network.
Using Your Device
Calling
Making Calls
Using a phone connected to your AT&T Home Base, place and receive calls as you normally would. The
AT&T Home Base supports both cordless and corded phone dialing methods.
Note: Make sure to dial the 10-digit phone number, including area code.
Three-Way Calling
While on an existing call, press the Flash (or Phone/Talk) key on your phone to put the first party on hold.
When you hear a dial tone, dial the second party's number (wait up to four [4] seconds). When the
second party answers, press the Flash (or Phone/Talk) key again to complete the three-way connection.
If the second party does not answer, press the Flash (or Phone/Talk) key to end the connection and
return to the first party.
Note: If your phone does not have a Flash (or Phone/Talk) key, use the off-hook mechanism supported
by your phone instead.
Call Waiting
You will hear two tones if someone calls while you are already on a call.
To hold the current call and accept the waiting call, press the Flash (or Phone/Talk) key. You can press
the Flash (or Phone/Talk) key anytime to switch back and forth between calls.
To clear the current call and accept the waiting call, enter "1" and press the Flash (or Phone/Talk) key.
To reject (User Busy) the waiting call, enter "0" and press the Flash (or Phone/Talk) key.
Notes:
To Next Page
Loading...
