Zte Consumer Cellular - Initial Set-Up; Battery Installation and Power Connection; Signal Strength Check and Placement

7
INITIAL SETUP
6
INITIAL SETUP
CONNECT THE POWER CORD
Insert the small end of the
power cord into the Power
Input port on the back of
your device.
Plug the power cord into an
electrical wall outlet that is not
powered by a wall switch.
Slide the On/O Switch to
the On position.
CHECK THE
WIRELESS SIGNAL
Raise the Antenna to an
upright position and check the
signal strength. More green
bars indicate a stronger signal.
Your device can be relocated
in your home for best
performance.
INITIAL SETUP
INSERT THE BATTERY
INSTALL THE BATTERY COVER
The battery must be installed at all times for your Wireless
Home Phone Base to operate properly, even when plugged
into a power source. It may take 5 hours to fully charge. The
battery will charge inside the device while connected to a
power supply.
NOTE: