32
Set Router options
To set the mobile hotspot’s LAN options:
1. On the AT&T Wi-Fi Manager home page, log in as Administrator.
2. Click Settings on the navigation menu on the left side.
3. Click the Advanced > Router tab.
4. Enter the desired information in the each section.
If the DHCP Server is enabled, it automatically assigns an IP address to each device on
the network and manages their configuration information.
5. Click Apply.
Troubleshooting
Problem Suggested Solution
Cannot establish the
Wi-Fi connection
between your device
and client.
Refresh network list and select the correct SSID.
Check the IP address to make sure your client can obtain an
IP address automatically in the Internet protocol (TCP/IP)
properties.
Type the correct network key (Wi-Fi password) when you
connect to the device.
The client connected
to the device cannot
access the Internet.
Make sure your SIM card is available.
Change the location to find a place with good signal.
Contact your service provider.
Cannot visit the web
user interface
configuration page.
Enter the correct address. The default address is
http://192.168.1.1 or http://attwifimanager/
Only use one network adapter in your PC.
Do not use any proxy server.
About the password On
screen to check the Main/ Guest Wi-Fi Network
password or check the label on the device to get them.
If you changed the password and forgot the new password,
you need to restore the device to the factory default settings.
Specifications
Mechanical specifications
Table 5-1: Mechanical specifications
Weight 130g
Dimensions 114x63x17mm
Display 2.4” QVGA TFT LCD
240x320 pixel
To Next Page
Loading...
