2.3 WLAN Configuration
2.3.1 Configuring Basic WLAN Parameters
Perform this procedure to configure the basic WLAN parameters.
1. From top menu bar, click on the Network tab and choose WLAN, then Basic.
2. Check the parameters in Table 2-1 match the contents of the main window of
Figure 2-2. Amend if required and click Submit to apply the changes.
Figure 2-2
Table 2-1 Parameter Description
**Note** All other parameters in this section should remain as default
Page 11
Parameter Description
Wireless RF Mode Set to Enabled – Options are Enabled, Disabled and Scheduled.
Mode Set to Mixed (802.11b+802.11g+802.11n)
Country/Region Set to United Kingdom or Other
Bandwidth Set to 20Mhz (Default setting)
Channel Set to Auto as default. (switches channels if interference is detected)
Transmit Power Default 100%
To Next Page
Loading...
