To Next Page

To Previous Page

2. Running Mode

● Forward w/o Reverse

This is a Race setting - Reverse is disabled.

You will find in racing, most tracks will not allow racing with reverse enabled.

● Forward with pause then Reverse: (DEFAULT)

General bashing around (FUN) or racing if reverse is allowed for the event. The Electronic

Speed Controller requires 2 seconds of continuous neutral from the transmitter prior to allowing

reverse to operate.

Note: There is automatic protection within the ZTW ESC. Only after you have stopped and

returned the trigger to neutral will reverse become available. If while traveling in reverse, pull

the trigger to go forward. This is to help prevent serious damage to the drive train.

● Forward / Reverse

If the option is actived, the RC car could go forward and backward, but couldn`t brake.

ESC – reverse operation

Should you get into a situation that requires reverse, after you have applied any brakes you may

have needed, return the throttle trigger to the neutral position. Wait a moment or two and then

push the trigger forward for reverse.

3. Motor Timing

This option affects the power band and efficiency (run time) of an electric motor. The default is

Questions and Answers:

Need help?

Do you have a question about the ZTW Beast SL 45A and is the answer not in the manual?

ZTW Beast SL 45A Specifications

General