2 Using for the first time
Before operating the newly installed appliance for the first time, the following steps
should be taken:
▸ Remove packaging and transport materials as well as any protective blue film from
out of the cooking space.
▸ Remove all the accessories from out of the cooking space.
▸ Clean the cooking space.
▸ Long touch the display.
– The appliance starts.
– Various user settings necessary for operation appear in the display one after the
other.
▸ Make the settings and confirm.
▸ Fill the water tank up to the «max.» mark with fresh, cold drinking water and slot into
position in the water tank compartment.
▸ Start the rinsing of the water system.
If the rinsing is skipped, it must be carried out manually.
▸ Heat the empty cooking space using the «Steam» application at 100°C for
about 5minutes.
– Wait 20 minutes until the appliance cools down and the water is pumped back.
▸ Wipe down and dry the cooking space.
▸ Start the initial burn-in.
If the initial burn-in step is skipped, it must be carried out manually after completing
the initial set-up.
▸ Heat the empty cooking space (without wire shelves, baking trays, etc.) using the
«Hot air» application at 200°C for about 30minutes.
As there is likely to be some smoke and odour given off during the initial burn-in,
we recommend ventilating the room well during this phase.
▸ Clean the filter in the water outlet.
If the outlet is blocked in spite of this, contact Customer Services.
All temperatures in these operating instructions are given in degrees Celsius (°C).
9
To Next Page
Loading...
Need help?
General
