X10 SIP Paging Gateway User Guide
${ip}: The current IP address of the device
${mac}: The current MAC address of the device
API Settings
Using the API interface to realize features such as device linkage, call control, relay control,
and play sound by the systems.
Note: Authentication and encryption are not used in the API interface, so please pay
attention to the security of the network environment when opening and using these API
interfaces.
5.4 Multicast
The multicast settings are used to configure the parameter settings of the multicast function
on the SIP Safety Intercom. It can be configured to monitor up to 9 different levels of
multicast addresses, the audio streams with a higher priority will interrupt the playback of the
lower priority audio streams.
Please go to Advanced ---> Multicast page to enable the multicast feature.
To Next Page
