ZyXEL Communications AES-100 - ADSL Configuration Commands

AES-100 User’s Guide
ADSL Configuration 5-3
5.5 ADSL Commands
5.5.1 Config Save Command
Syntax:
192.168.1.1 adsl> config save
The config save command saves the ADSL configuration into nonvolatile memory.
5.5.2 Disable Port Command
Syntax:
192.168.1.1 adsl> disable port <port number>
where
<port number> = port number, from 1 to 8
The
disable port command forcibly disables the specified ADSL port.
The factory default of all ports is disabled. A port must be enabled before data transmission can occur. An
enabled but disconnected ADSL port generates more heat than an operating port. To minimize heat
generation and to enhance reliability, remember to disable a port when it is not in use.
5.5.3 Disable Ports Command
Syntax:
192.168.1.1 adsl> disable ports
The disable ports command forcibly disables all ADSL ports.
The factory default of all ports is disabled. A port must be enabled before data transmission can occur. An
enabled but disconnected ADSL port generates more heat than an operating port. To minimize heat
generation and to enhance reliability, remember to disable a port when it is not in use.
5.5.4 Enable Port Command
Syntax:
192.168.1.1 adsl> enable port <port number>
where
<port number> = port number, from 1 to 8
The
enable port command forcibly enables the specified ADSL port.
The factory default of all ports is disabled. A port must be enabled before data transmission can occur. An
enabled but disconnected ADSL port generates more heat than an operating port. To minimize heat
generation and to enhance reliability, remember to disable a port when it is not in use.
5.5.5 Enable Ports Command
Syntax: