AMG1202-T10B/AMG1302-T10B
Support Notes
10
All contents copyright © 2013 ZyXEL Communications Corporation.
Product FAQ
1. How can I manage AMG1202-T10B/AMG1302-T10B?
Multilingual Embedded Web GUI for Local and Remote management
CLI (Command-line interface)
Telnet support (Administrator Password Protected ) for remote
configuration change and status monitoring
2. What is the default password for Web Configurator?
There are two different accounts for AMG1202-T10B/AMG1302-T10B Web
Configurator: Common User Account and Administrator Account.
By factory default the password for the two accounts are:
Common User Account: 1234
Administrator Account: 1234.
You can change the password after you logging in the Web Configurator.
Please record your new password whenever you change it. The system
will lock you out if you have forgotten your password.
3. What’s the difference between ‘Common User Account’ and
‘Administrator Account’?
For Common User Account, it can only access the status monitor of
AMG1202-T10B/AMG1302-T10B and check the current system status.
For Administrator Account, besides accessing the status monitor of
AMG1202-T10B/AMG1302-T10B, it can also access Wizard setup/ Advanced
setup of AMG1202-T10B/AMG1302-T10B:
Moreover, only with Administrator Password, you could manage the
AMG1202-T10B/AMG1302-T10B via FTP/TFTP or Telnet.
4. How do I know the AMG1202-T10B/AMG1302-T10B’s WAN IP
address assigned by the ISP?
You can view "My WAN IP <from ISP> : x.x.x.x" shown in Web Configurator
‘Status->Device Information ->WAN Information’ to check this IP address.
To Next Page
Loading...
