Chapter 1 Introduction
NBG7815 User’s Guide
14
1 Make sure the power LED is on (not blinking).
2 Open the Web Configurator.
3 Click Settings > WiFi > WPS, and the press the WPS button.
4 Press the WPS button on another WPS-enabled device within range of the NBG7815.
Note: You must activate WPS in the NBG7815 and in another wireless device within two
minutes of each other.
For more information on using WPS, see Section 7.2 on page 43.
1.7 LEDs
Figure 4 Front Panel
The following table describes the front panel LED.
Table 1 Front Panel LED
COLOR STATUS DESCRIPTION
White On The NBG7815 is receiving power.
Blinking The NBG7815 is booting.
Dark Blue On Blue tooth is ready.
Blinking Blue tooth configuration is in process.
To Next Page
Loading...
