EMG6726/8726-B10A User’s Guide
193
CHAPTER 18
MAC Filter
18.1 Overview
You can configure the EMG to permit access to clients based on their MAC addresses in the MAC Filter
screen. This applies to wired and wireless connections. Every Ethernet device has a unique MAC (Media
Access Control) address. The MAC address is assigned at the factory and consists of six pairs of
hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the MAC addresses of the
devices to configure this screen.
18.2 The MAC Filter Screen
Use this screen to allow wireless and LAN clients access to the EMG. Click Security > MAC Filter. The
screen appears as shown.
Figure 127 Security > MAC Filter
To Next Page
Loading...
