1/3
Step 1
Hardware Installation
Step 2
WiFi Connection A or B
EX7710-B0
AX11000 WiFi 6E 10G Ethernet Gateway
Copyright © 2023 Zyxel and/or its affiliates. All Rights Reserved.
US Importer
Zyxel Communications, Inc
1130 North Miller Street Anaheim, CA 92806-2001
https://www.zyxel.com/us/en/
The Power /Internet /WiFi /WPS LEDs will light up when the setup is complete.
Note: If the lights do not turn on, please retry or contact your service provider for assistance.
1
2
Quick Start Guide
Method A: SCAN QR code to connect WiFi
Package Contents
EX7710-B0 Power Adapter Ethernet Cable Quick Start Guide
POWER
Blue
On - Power is on.
INTERNET
Blinking - Starting up.
Red
On - System failure.
Blinking - Upgrading firmware.
On - Internet is ready.
Blinking -
Red
On -
On - 2.4G, 5G and 6G wireless
connections are ready.
Off - 2.4G or 5G or 6G wireless
connection is not ready or failed.
Attempt to get an IP address failed.
Transmitting/receving
internet data.
Internet
xDSL/Cable/
Fiber modem
A member of the Zyxel MPro Mesh™ PLUS solution family.
MPro Mesh™ PLUS Solution:
• EX7710-B0
• WX5610-B0
• MPro Mesh™ PLUS App
Visit www.zyxel.com/us/en for updated information.
Use the included Ethernet cable to connect the
xDSL/cable/fiber modem’s LAN port to the EX7710-B0’s
10G WAN port as illustrated.
Connect the power adapter to the EX7710-B0 and
wait for 2 minutes. Check the EX7710-B0 front panel.
1
2
3
The label on the bottom of the EX7710-B0 provides 2 ways to connect your wireless device to WiFi:
Method A: Scan QR code or Method B: Using SSID
1
2
3
Use your wireless device to scan the QR code on the EX7710-B0’s bottom label.
After scanning the QR code, join this WiFi network and you can surf the internet.
1
2
B. Using the SSID method to connect WiFi
The WiFi network is on the EX7710-B0’s bottom label.
On your wireless device, find this SSID and enter the WiFi Password on
your wireless clients to surf the internet.
WPS
Off - No WPS activity.
Blinking - WPS in progress.
WiFi
Blue
Blue
Green
Blinking -
Transmitting/receving data.
Orange
Blinking - IPTV SSID is paring.
“ZyxelXXXXXX”
Zyxelxxxxxx
See the User's Guide at www.zyxel.com for more information,
including customer support and safety warnings.
Support information
https://service-provider.zyxel.com/global/en/tech-support
To Next Page
Need help?
General
