Is the device or operation working accordingly?
If the device or operation is working accordingly, go to step 3.
If the device or operation does not work accordingly, go to step 4.
Are any policies previously disabled?
If any policies were disabled on step 5, reactivate these policies and go to step 7.
If there were no disabled policies from step 5, proceed to the next agenda.
Are there any remaining counting classifiers with policies still
active?
Counting classifiers are the classifiers whose counters were rising in step 5.
If there are still active policies among the counted classifiers, go to step 5.
If there are no more active policies, reactivate all policies and proceed to
<OTHERS>.
Identify the policies that are affecting traffic.
Select each configured classifiers and check “Log”. This will allow the switch to
count the real time number of packets affected by this classifier. This will help narrow
down which classifier may have affected or interrupted service.
To Next Page
Loading...
