Using CLI:
Figure 17
After capturing the client with issue’s traffic, proceed to step 13.
Does the client with issue’s ARP reply sent to the switch’s
physical MAC address?
Examine the packet capture of the client with issue’s traffic. Locate the client with
issue’s ARP replies from the switch’s ARP request. Verify whether the client with issue’s
ARP replies are sent to the switch physical MAC address instead of the VRRP’s virtual
MAC address.
If the client with issue sends ARP replies destined for the switch’s physical address, go
to step 14.
If the client with issue sends ARP replies destined for the switch’s virtual address, this is
a design limitation.
Did symptom only occur after client with issue move from
one uplink port to another?
Uplink port refers to port of the Uplink Gateway which leads to the client with issue.
To Next Page
Loading...
