Using CLI:
Figure 3 Enter CLI command “show mac address-table all”
If MAC address of the device does appear, go to step 3.
If MAC address of the device does not appear, go to <OTHERS>
Is the MAC address of the device with issue being processed
on the correct VID?
WebGUI:
Figure 4 Management > MAC Table
CLI:
Figure 5 Enter CLI command “show mac address-table all”
If MAC address of the device is processed in the correct VID, go to step 4.
If MAC address of the device is not processed in the correct VID, go to step 5.
To Next Page
Loading...
