Configure using CLI:
Figure 35
If IGMP is not enabled in the multicast client’s network, the Layer 3 IGMP
Router will not stream video on that network.
If the interface or network of the multicast client does not have IGMP enabled,
reconfigure and repeat step 4.
If the interface or network of the multicast client has IGMP enabled already, go to
step 9.
Are there any other switch between the IGMP querier and
the multicast client?
If there are other switches between the IGMP querier and the multicast client,
access the Layer 2 non-querier switch and move on to step 3 of the Layer 2 IGMP
Snooping Troubleshooting section.
If there are no other switches between the IGMP querier and the multicast client, go
to <OTHERS>.
To Next Page
Loading...
