ZyXEL Communications ES-4124 - Set Port VID; Set Acceptable Frame Type; Enable or Disable Port GVRP

ES-4124 User’s Guide
330 Chapter 46 IEEE 802.1Q Tagged VLAN Commands
46.3.1 Set Port VID
Syntax:
pvid <VID>
where
This command sets the default VLAN ID on the port(s).
The following example sets the default VID to 200 on ports 1 to 5.
46.3.2 Set Acceptable Frame Type
Syntax:
frame-type <all|tagged|untagged>
where
This command sets the specified port to accept all Ethernet frames or only those with an IEEE
802.1Q VLAN tag.
The following example sets ports 1 to 5 to accept only tagged frames.
46.3.3 Enable or Disable Port GVRP
Use the gvrp command to enable GVRP on the port(s). Use the no gvrp command to disable
GVRP.
The following example turns off GVRP for ports 1 to 5.
<VID>
= Specifies the VLAN number between 1 and 4094.
sysname (config)# interface port-channel 1-5
sysname (config-interface)# pvid 200
<all|tagged|
untagged>
= Specifies all Ethernet frames (tagged and untagged), only tagged
Ethernet frames or only untagged Ethernet frames.
sysname (config)# interface port-channel 1-5
sysname (config-interface)# frame-type tagged
sysname (config)# interface port-channel 1-5
sysname (config-interface)# no gvrp