ZyXEL Communications GS1100-16 - Getting to Know Your Switch; 1.1 Introduction; 1.2 Features

Chapter 2 Hardware Description and Connection
GS1100 Series User’s Guide
11
2 Press the transceiver firmly until it clicks into place.
3 The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is
functioning properly.
4 Close the transceiver’s latch (latch styles vary).
5 Connect the fiber optic cables to the transceiver.
Figure 6 Transceiver Installation Example
Figure 7 Connecting the Fiber Optic Cables
2.2.3.2 Transceiver Removal
Use the following steps to remove a SFP module.
1 Remove the fiber optic cables from the transceiver.
2 Open the transceiver’s latch (latch styles vary).
3 Pull the transceiver out of the slot.
Figure 8 Removing the Fiber Optic Cables
Figure 9 Opening the Transceiver’s Latch Example