ZyXEL Communications GS1900-24E - The Trap Destination Screen

Chapter 32 Configuration: Management
GS1900 Series User’s Guide
222
Fig ure 226 Configuration > Management > SNMP > Trap
The following table describes the labels in this screen.
32.3.9 The Tra p De stina tio n Sc re e n
Use this screen to view the Tra p De stina tion settings. Click Config ura tion > Ma na g e m e nt > SNMP > Tra p
De stina tion to open this screen.
Fig ure 227 Configuration > Management > SNMP > Trap Destination
The following table describes the labels in this screen.
Table 174 Configuration > Management > SNMP > Trap
LABEL DESCRIPTIO N
SNMP Trap
SNMP Authfailure
Trap State
Select the SNMP entity is permitted to generate authentication failure traps. Possible modes
are:
• Ena ble d : Enable SNMP trap authentication failure.
• Disa ble d: Disable SNMP trap authentication failure.
SNMP LinkupDown
Trap State
Select the SNMP trap link-up and link-down mode operation. Possible modes are:
• Ena ble d : Enable SNMP trap link-up and link-down mode operation.
• Disa ble d: Disable SNMP trap link-up and link-down mode operation.
SNMP Warm-Start
Trap State
Reboot using software or hardware button reboot.
SNMP Cold-Start Trap
State
Reboot though power off.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
Table 175 Configuration > Management > SNMP > Trap Destination
LABEL DESCRIPTIO N
SNMP Trap Host
Server Displays a string identifying the server address that this entry belongs to.