Chapter 2 Hardware Installation and Connection
GS1900 Series User’s Guide
24
2.4 Wa ll Mo unting
You may need screw anchors if mounting on a concrete or brick wall.
2.4.1 Wa ll- m o unte d Insta lla tio n Re quire me nt
The following are the wall-mounted installation requirements:
• Use screws with 6 mm – 8 mm (0.24" – 0.31") wide heads.
• See the following table for how far apart to place the screws.
The following figure shows the screw specifications used for wall mounting.
• D = 7.00 mm
• H = 2.00 mm
• L= 15.50 mm
• d = 3.50 mm
Do the following to attach your Switch to a wall.
1 Select a position free of obstructions on a wall strong enough to hold the weight of the Switch.
2 Mark two holes on the wall at the appropriate distance apart for the screws.
WARNING ! Be c a re ful to a vo id da m a g ing pipe s o r c a ble s lo c a te d inside
the wa ll whe n drilling ho le s fo r the sc re ws.
3 If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full
depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave
a small gap. The gap must be big enough for the screw heads to slide into the screw slots and the
connection cables to run down the back of the Switch.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all
the way in – leave a gap.
Table 2 Distance between the centers of the holes for wall mounting
G S1900- 8 G S1900- 8HP G S1900- 10HP G S1900- 16 G S1900- 24E
176 mm 176 mm 176 mm 148 mm 207 mm
To Next Page
Loading...
