Chapter 19 Configuration: Port
GS1900 Series User’s Guide
125
19.5.2 The Po rt Ra te Edit Sc re e n
Use this screen to configure port rate Bandwidth Management settings. Click C o nfig ura tion > Po rt >
Ba ndwidth Ma na g e m e nt > Eg re ss G lo ba l Burst > Edit to open this screen.
Fig ure 122 Configuration > Port > Bandwidth Management > Egress Global Burst > Edit
The following table describes the labels in this screen.
19.6 Sto rm C o ntro l
Broadcast storm control limits the number of broadcast, multicast and destination lookup failure (DLF)
packets the Switch receives per second on the ports. When the maximum number of allowable
broadcast, multicast and/or DLF packets is reached per second, the subsequent packets are
discarded. Enable this feature to reduce broadcast, multicast and/or DLF packets in your network. You
can specify limits for each packet type on each port.
Edit Select this check box to configure the properties of a port. Click the Edit button change the
properties of the port.
Cancel Click C a nc e l to discard the changes.
Table 69 Configuration > Port > Bandwidth Management > Egress Global Burst (continued)
LABEL DESCRIPTIO N
Table 70 Configuration > Port > Bandwidth Management > Egress Global Burst > Edit
LABEL DESCRIPTIO N
Port Rate
Port List Displays the list of port index numbers that are being configured.
Ingress State Select Ena b le to activate ingress peak rate limits on the ports.
Ingress
Bandwidth
(Kbps)
Enter the maximum bandwidth allowed in kilobits per second (Kbps) for the outgoing traffic flow
on a port.
Egress State Select Ena ble to activate egress peak rate limits on the ports.
Egress
Bandwidth
(Kbps)
Enter the maximum bandwidth allowed in kilobits per second (Kbps) for the outgoing traffic flow
on a port.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
To Next Page
Loading...
