Chapter 33 Maintenance
GS1900 Series User’s Guide
241
Click Ca nc e l to discard the changes.
The test results are displayed in Re sults.
33.7.4 Tra c e Ro ute
Click Ma inte na nc e > Dia g no stic s > Tra c e > Tra c e Ro ute in the navigation panel to open this screen. Use
this screen to print the route that IP packets take to a network host.
Fig ure 246 Maintenance > Diagnostics > Trace > Trace Route
The following table describes the labels in Tra c e Ro ute .
Follow the steps to perform a trace route.
1. In IP Addre ss, enter the IPv6 address.
2. In Ho p s, enter the number of hops.
3. Click Ap ply to perform the test.
OR
Click Ca nc e l to discard the changes.
The test results are displayed in Re sult.
Table 193 Maintenance > Diagnostics > Trace > Trace Route
LABEL DESCRIPTIO N
Trace Route
IP Address Enter the address of the target host server.
Hops Enter the maximum number of time-to-live or hops used in outgoing probe packets. The range is
2 to 255 packets; the default is 30 hops.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
To Next Page
Loading...
