ZyXEL Communications GS1900 Series - Page 239

Chapter 33 Maintenance
GS1900 Series User’s Guide
239
Fig ure 244 Maintenance > Diagnostics > PING > IPv4
The following table describes the labels under Ping Te st.
Follow the steps to perform a ping test.
1. In IP Addre ss, enter the IPv4 address.
2. In Count, enter the number of ping packets.
3. In Inte rva l, enter the time interval in seconds.
4. In Size , enter the packet size in bytes
5. Click Ap ply to perform the ping test.
OR
Click Ca nc e l to discard the changes.
The test results are displayed in Re sults.
Table 191 Maintenance > Diagnostics > PING > IPv4
LABEL DESCRIPTIO N
Ping Test
IP Address Enter the address of the target host server.
Count Enter the number of ping packets to send. The range is 1 to 5 packets; the default count is 4.
Interval Enter the time in seconds between sending ping packets. The range is 1 to 5 seconds; the
default is 1 second.
Size Enter the individual packet size in bytes. The range is 8 to 5120 bytes; the default is 56 bytes.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.