ZyXEL Communications GS1900 Series - Page 46

Chapter 5 Web Configurator
GS1900 Series User’s Guide
46
G e tting Sta rt screen appears every time you log in using the default user name and default password.
5 If you did not change the default administrator password and/or SNMP community values, a warning
screen displays each time you log into the Web Configurator. Click Pa sswo rd / SNMP to open a screen
where you can change the administrator and SNMP passwords simultaneously. Otherwise, click Ignore
to close it.
Fig ure 50 Web Configurator: Warning
Fig ure 51 Web Configurator: Password
Change the default administrator and/or SNMP passwords, and then click Apply to save your changes.
Table 7 Web Configurator: Password > Users/SNMP
LABEL DESCRIPTION
User This is the default administrator account with the “admin” user name. You cannot change the
default administrator user name.
Old Password Type the existing system password (1234 is the default password when shipped).
New Password Enter your new system password.
New Password
Confirm
Retype your new system password for confirmation.
SNMP
Use this section to specify the SNMP community (password) and access right values.
Community Enter a string identifying the community name that this entry should belong to. The allowed
string length is 1 to 20, and the allowed content is ASCII characters from 33 to 126.
Access Right Select the access mode for this entry. The possible values are Re a d- Only and Re a d- Write .