Chapter 3 Hardware Overview
GS1910/XGS1910 Series User’s Guide
21
Figure 19 Rear Panel: GS1910-24HP
Figure 20 Front Panel: GS1910-48
Figure 21 Front Panel: GS1910-48HP
Figure 22 Front Panel: XGS1910-24
Figure 23 Front Panel: XGS1910-48
3.2.1 Power Connector
Make sure you are using the correct power source as shown on the panel and that
no objects obstruct the airflow of the fans.
Use the following procedures to connect the Switch to a power source after you
have installed it.
1 Connect the female end of the power cord to the power socket of your Switch.
2 Connect the other end of the cord to a power outlet.
Keep the power supply switch and the Switch’s power switch in
the OFF position until you come to the procedure for turning on
the power.
Note: Use only power wires of the required diameter for connecting the Switch to a
power supply.
To Next Page
Loading...
