Chapter 5 Tutorials
GS1910/XGS1910 Series User’s Guide
53
5.10.1 Configuring Mirroring
In this example, you are attached to port 2 but want to copy traffic received or transmitted on port
7 for analysis.
1 Access the Switch through http://192.168.1.1. Log into the Switch by entering the username
(default: admin) and password (default: 1234).
2 Go to Configuration > Port Mirroring. Select Enabled in the Mode field to activate mirroring on
the Switch.
3 Set Type to Mirror to do mirroring in one standalone switch.
4 Configure port 2 to act as a destination port to which the Switch copy traffic from the source
port(s).
5 Select the direction of traffic flow you want to copy (Both in this example) on port 7.
6 Click Save. You then should be able to receive a copy of the traffic passing through port 7 to
examine it in more detail without interfering with the traffic flow on the original port.
To Next Page
Loading...
