Chapter 5 Tutorials
GS1910/XGS1910 Series User’s Guide
64
2 Go to Configuration > Security > Network > ACL > Access Control List. Click the Add icon
to create a new ACL policy.
3 Select the port on which the matched traffic is received (All ports in this example).
4 Set Policy Filter to Specific and Policy Bitmask to 0xff to give this policy one ID number in the
Policy Value field. You then can apply this policy to a port using this policy ID.
5 Select IPv4 in the Frame Type field.
6 Select Network in the DIP Filter field and specify the destination address and subnet mask of
matched traffic in this policy.
7 Set Action to Deny to block all mattached traffic.
To Next Page
Loading...
