ZyXEL Communications GS2200-24 - Link Aggregation Control Protocol

Chapter 17 Link Aggregation
GS2200-24 User’s Guide
157
17.6 Link Aggregation Control Protocol
Click Advanced Application > Link Aggregation > Link Aggregation Setting
> LACP to display the screen shown next. See Section 17.3.1 on page 152 for
more information on dynamic link aggregation.
Figure 77 Advanced Application > Link Aggregation > Link Aggregation Setting >
LACP
The following table describes the labels in this screen.
Table 40 Advanced Application > Link Aggregation > Link Aggregation Setting >
LACP
LABEL DESCRIPTION
Link
Aggregation
Control
Protocol
Note: Do not configure this screen unless you want to enable
dynamic link aggregation.
Active Select this checkbox to enable Link Aggregation Control Protocol (LACP).