Chapter 5 Initial Setup Example
GS2200-24 User’s Guide
53
5.1.2 Setting Port VID
Use PVID to add a tag to incoming untagged frames received on that port so that
the frames are forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any
untagged frames received on that port get sent to VLAN 2.
Figure 18 Initial Setup Network Example: Port VID
1 Click Advanced
Applications > VLAN in
the navigation panel. Then
click the VLAN Port
Setting link.
2 Enter 2 in the PVID field
for port 1 and click Apply
to save your changes back
to the run-time memory.
Settings in the run-time
memory are lost when the
Switch’s power is turned
off.
To Next Page
Loading...
