Chapter 4 Tutorials
WiMAX Device Configuration User’s Guide
37
4 Log into the Web Configurator and open the Network Setting > LAN > DHCP screen.
5 Select Server for the DHCP mode, then enter 192.168.100.10 and 192.168.100.30 as your DHCP
starting and ending IP addresses.
6 Leave the other settings as their defaults and click Save.
7 Next, go to the Network Setting > WAN screen and select NAT in the Operation Mode field.
Click Save.
8 Connect your computers to the WiMAX Device’s Ethernet ports and you’re all set!
Note: You may need to configure the computers on your LAN to automatically obtain IP
addresses. For information on how to do this, see Appendix B on page 209.
To Next Page
Loading...
