Chapter 4 Tutorials
WiMAX Device Configuration User’s Guide
51
Click Network Setting > WAN. Change the WiMAX Device to bridge mode and then click Save. If
you cannot obtain IP address settings from a WAN DHCP server, select User as the Get IP Method
and enter the WAN IP Address, WAN IP Subnet Mask and Gateway IP Address.
4.12.1 Scenario 1
In this scenario, PC A is connected directly to interface LAN1 on the WiMAX Device. PC B is
connected to interface WiMAX and interface IAD for managing the WiMAX Device.
Figure 16 VLAN Configuration Example 1
A
B
No VLAN Tag
No VLAN Tag
No VLAN Tag
CPE
LAN
Manager IP
No VLAN Tag
No VLAN Tag
No VLAN Tag
User Network
PC
Manager IP: No VLAN Tag
LAN: Transparent
Network
operators
Transparent
To Next Page
Loading...
