ZyXEL Communications MAX208M - Page 47

Chapter 4 Tutorials
WiMAX Device Configuration User’s Guide
47
In the following figure, router R is connected to the WiMAX Device’s LAN. R connects to two
networks, N1 (192.168.1.x/24) and N2 (192.168.10.x/24). If you want to send traffic from
computer A (in N1 network) to computer B (in N2 network), the traffic is sent to the WiMAX
Device’s WAN default gateway by default. In this case, computer B will never receive the traffic.
You need to specify a static routing rule on the WiMAX Device to specify R as the router in charge of
forwarding traffic to N2. In this case, the WiMAX Device routes traffic from computer A to R and
then R routes the traffic to computer B.
This tutorial uses the following example IP settings:
Table 10 IP Settings in this Tutorial
DEVICE / COMPUTER IP ADDRESS
The WiMAX Device’s WAN 172.16.1.1
The WiMAX Device’s LAN 192.168.1.1
A 192.168.1.34
R’s IP address on N1 192.168.1.253
N2
B
A
R
N1
N2
B
N1
A
R