Chapter 4 Configuration
NSG Series User’s Guide
25
4.4 USB Storage
The NSG can use a connected USB device to store the packet capture files and diagnostic information.
Use this screen to turn on this feature and set a disk full warning limit.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and use the
FAT16, FAT32, EXT2, or EXT3 file system.
Click Configuration > USB Storage to open the screen as shown next.
Figure 25 Configuration > SUSB Storage
The following table describes the labels in this screen.
Table 12 Configuration > USB Storage
LABEL DESCRIPTION
Activate USB
storage service
Select this if you want to use the connected USB device(s).
Disk full warning
when remaining
space is less than
Set a number and select a unit (MB or %) to have the NSG send a warning message when the
remaining USB storage space is less than the value you set here.
Apply Click Apply to save your changes back to the NSG.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
