Chapter 5 Maintenance
NSG Series User’s Guide
32
The following table describes the labels in this screen.
Table 17 Maintenance > Diagnostics > Network Tool
LABEL DESCRIPTION
Network Tool Select PING IPv4 to ping the IP address that you entered.
Select TRACEROUTE IPv4 to perform the traceroute function. This determines the path a
packet takes to the specified computer.
Domain Name or IP
Address
Type the IPv4 address of a computer that you want to perform ping or traceroute in
order to test a connection.
Interface Select an interface through which the packet is transmitted.
Extension Option Enter the extended option if you want to use an extended ping or traceroute
command. For example, enter “-c count” (where count is the number of ping
requests) to set how many times the NSG pings the destination IP address, or enter “-w
waittime” (where waittime is a time period in seconds) to set how long the NSG waits
for a response to a probe before running another traceroute.
Test Click this button to start to ping or run a traceroute.
Stop Click this button to terminate the current ping operation or traceroute.
Reset Click this button to return the screen to its last-saved settings.
To Next Page
Loading...
