NWA5000 / WAC6000 Series User’s Guide
180
CHAPTER 16
LEDs
16.1 Overview
The LEDs of your NWA/WAC can be controlled such that they stay lit (ON) or OFF after the NWA/
WAC is ready. There are two features that controls the LEDs of your NWA/WAC - Locator and
Suppression.
16.1.1 What You Can Do in this Chapter
•The Suppression screen (Section 16.2 on page 180)) allows you to set how you want the LEDs
to behave after the device is ready.
•The Locator screen (Section 16.3 on page 181) allows users to see the actual location of the
NWA/WAC between several devices in the network.
16.2 Suppression Screen
The LED Suppression feature allows you to control how the LEDs of your NWA/WAC behave after it’s
ready. The deafult LED suppression setting of your AP is different depending on your NWA/WAC
model.
You can go to the Maintenance > LEDs > Suppression screen to see the default LED behavior
and change the LED suppression setting. After you make changes in the suppression screen, it will
be stored as the default when the NWA/WAC is restarted. See (Section 1.6 on page 20) for
information on default values for different models.
Note: When the NWA/WAC is booting or performing firmware upgrade, the LEDs will lit
regardless of the setting in LED suppression.
To access this screen, click Maintenance > LEDs > Suppression.
To Next Page
Loading...
