Chapter 5 Network
NWA5000 / WAC6000 Series User’s Guide
67
Figure 34 Configuration > Network > AC Discovery
Each field is described in the following table.
Table 31 Configuration > Network > AC Discovery
LABEL DESCRIPTION
Discovery Setting
Auto Select this option to use DHCP option 138/DNS SRV record/Broadcast to get the
AP controller’s IP address.
Manual Select this option and enter the IP address of the AP controller manually. This is
necessary when the AP Controller is not in the same subnet and you want it to
manage the NWA/WAC.
Primary / Secondary
Static AC IP
Specify the primary and secondary IP address of the AP controller to which the
NWA/WAC connects.
Disable Select this to manage the NWA/WAC using its own web configurator, neither
managing nor managed by other devices. Please note if an AP Controller is in the
same subnet, you will need to click Disable if you do not want the NWA/WAC to
be managed.
Apply Click Apply to save the information entered in this screen.
If you change the mode in this screen, the NWA/WAC restarts. Wait a short while
before you attempt to log in again. If you changed the mode to Managed AP,
the AP controller uploads the firmware package for managed AP mode to the
NWA/WAC and you cannot log in as the web configurator is disabled; you must
manage the NWA/WAC through the AP controller on your network.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
