ZyXEL Communications P-330W - IP Filtering; IP Filtering Configuration

29
Enable Log
Click to enable log function.
Enable Remote Log
Click to enable the remote log function. The log record will be
saved into a remote server.
System all:
Wireless only:
Dos only:
Save
After completing the settings on this page, click Save to save the
settings.
Refresh
Click to refresh the logs.
Clear
Click to delete the logs.
IP Filtering
Enable IP Filtering
Check to enable the IP filtering function.
Local IP Address
Enter the client IP address.
Protocol
Select the protocol (TCP, UDP or Both) used to the remote system
or service.
Description
You may key in a description for the local IP address
Current Filter Table
Shows the current filter information.
Save
After completing the settings on this page, click Save to save the
settings.
Reset
Click Reset to restore to default values.