Chapter 10 Wireless LAN
PLA4231 User’s Guide
76
The following table describes the labels in this screen.
10.6 MAC Filter
The MAC filter screen allows you to configure the PLA4231 to give exclusive access to devices
(Allow) or exclude devices from accessing the PLA4231 (Deny). Every Ethernet device has a unique
MAC (Media Access Control) address. The MAC address is assigned at the factory and consists of six
pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the MAC
address of the devices to configure this screen.
To change your PLA4231’s MAC filter settings, click Network > Wireless LAN > MAC Filter. The
screen appears as shown.
Table 21 Network > Wireless LAN > Security: WPA-PSK/WPA2-PSK
LABEL DESCRIPTION
Security Mode Select WPA-PSK or WPA2-PSK to enable data encryption.
WPA-PSK
Compatible
This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to connect to
your PLA4231.
Pre-Shared Key WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Group Key Update
Timer
The Group Key Update Timer is the rate at which the AP sends a new group key out to
all clients.
The default is 3600 seconds (60 minutes).
Apply Click Apply to save your changes back to the PLA4231.
Cancel Click Cancel to reload the previous configuration for this screen.
To Next Page
Loading...
