Chapter 13 Maintenance
PLA4231 User’s Guide
92
The following table describes the labels in this screen.
13.4 Password Screen
It is strongly recommended that you change your PLA4231's password.
If you forget your PLA4231's password (or IP address), you will need to reset the device. See
Section 13.8 on page 97 for details
Click Maintenance > Password.
Figure 61 Maintenance > Password
The following table describes the labels in this screen.
13.5 Time Setting Screen
Use this screen to configure the PLA4231’s time based on your local time zone. To change your
PLA4231’s time and date, click Maintenance > Time. The screen appears as shown.
Table 31 Maintenance > General
LABEL DESCRIPTION
Administrator
Inactivity Timer
Type how many minutes a management session can be left idle before the session times
out. The default is 5 minutes. After it times out you have to log in with your password
again. Very long idle timeouts may have security risks. A value of "0" means a
management session never times out, no matter how long it has been left idle (not
recommended).
Apply Click Apply to save your changes back to the PLA4231.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 32 Maintenance > Password
LABEL DESCRIPTION
Old Password Type the default password or the existing password you use to access the system in
this field.
New Password Type your new system password (up to 30 characters). Note that as you type a
password, the screen displays an asterisk (*) for each character you type.
Retype to Confirm Type the new password again in this field.
Apply Click Apply to save your changes back to the PLA4231.
Cancel Click Cancel to reload the previous configuration for this screen.
To Next Page
Loading...
