Chapter 1 Introduction
PM7516-R0 / PM7116-R0 User’s Guide
12
1.4.4 Reset Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button on the rear panel of the device to reload the factory system configuration. This means that you
will lose all configurations that you had previously and the password will be reset to the default.
1 Make sure the POWER LED is on (not blinking).
2 Press the RESET button for more than 5 seconds or until the POWER LED begins to blink. Wait for the
POWER LED to turn solid green. At this point, the device is reset to factory default settings.
Figure 6 Reset Button (PM7516-R0)
4GND
5GND
6 UPS status: Replace battery
7 UPS status: Low battery
8NA
Table 4 UPS Port Pin Assignment (continued)
PIN UPS PORT
To Next Page
Loading...
