SBG3300-N Series
5
• The DSL light is green when your Device has an ADSL connection. It is
orange when you have a VDSL connection.
• The WLAN light flashes green when WLAN is activated and orange while
WPS is in process. It stays on green when the wireless LAN is ready and
blinks when there is traffic.
• The INTERNET light turns on when the gateway is able to access the
Internet and will blink when your Device is sending or receiving data.
If the lights do not come on, check your connections and inspect your cables for
damage. If the lights are still off, contact technical support.
a. Network standby power consumption < 12 W
b. Off mode power consumption < 0.5 W
Set Up a Wireless Network
You can set up a wireless network manually. The wireless LAN on your Device
is enabled by default. If the WLAN light is off, press the WLAN button at the
front of the Device for one second. Once the WLAN light turns green, the
wireless network is active. Use the Network Setting > Wireless > General
screen to enable or disable this button.
To add a wireless client to the network, use the settings found on the side panel
of your Device, which will look similar to the following example:
Configure wireless devices that you want to connect to the wireless network to
use the same wireless settings as the Device.
The default wireless settings vary for each Device. Refer to the rear panel
of your device and use the provided information.
To Next Page
Loading...
