Chapter 1 VMG Introduction
VMG4927-B50A / VMG9827-B50A / VMG3927-B50B User’s Guide
29
The following table describes the items on the rear panels.
1.4.5 RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you will
lose all configurations that you had previously and the password will be reset to the factory default (see
the device label).
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for more than five seconds
or until the POWER LED begins to blink and then release it.
When the POWER LED begins to blink, the defaults have been restored and the device restarts.
1.4.6 Wall Mounting
You may need screw anchors if mounting on a concrete or brick wall.
The following figure introduces the specifications of the screws and screws anchors for wall mounting.
Rear Panel Ports
LABEL DESCRIPTION
DSL Connect a RJ-11 cable to the DSL port for Internet access. See Section 1.1.1.1 on page 17 for more
information about DSL bonding.
ETHERNET 1 ~
4
Connect computers or other Ethernet devices to Ethernet ports for Internet access.
LAN/WAN Connect an Ethernet cable to the Ethernet WAN port for Internet access. See Section 1.1.1.2 on
page 19 for more information about converting the LAN/WAN port as a WAN port.
USB The USB port is reserved for future development.
PHONE1 ~
PHONE2
Connect analog phones to the phone ports to make phone calls.
Reset Press the button to return the VMG to the factory defaults.
Power Connect the power cable to start the VMG.
Table 5 Wall Mounting Information
Distance between holes 88 mm
Screws Two
Screw anchors (optional) Two
Distance from the ground (maximum) 2 m
To Next Page
Loading...
