ZyXEL Communications VMG9827-B50A - Configure Wireless Security on the VMG; Connect to the Vmgs Wifi Network Manually (no WPS)

Chapter 4 Tutorials
VMG4927-B50A / VMG9827-B50A / VMG3927-B50B User’s Guide
49
Example WPS Process: PBC Method
4.3.3 Connect to the VMG’s WiFi Network Manually (No WPS)
In this example, we change the VMG’s wireless settings, and then manually select the VMG’s new SSID
and enter the WiFi key to connect a wireless client to the VMG.
4.3.4 Configure Wireless Security on the VMG
This section shows you how to configure wireless security settings with the following parameters on your
VMG.
Follow the steps below to configure the wireless settings on your VMG.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see Section 2.2 on page 28).
1 Go to the Network Setting > Wireless > WiFi > Edit screen to enable the 2.4G wireless network.
Wireless Client
SECURITY INFO
COMMUNICATION
WITHIN 2 MINUTES
VMG
WPS
Press and hold for
more than 5 seconds
Frequency Band 2.4G
SSID SSID_Example
Channel Auto
Security WPA2-PSK
(Wireless Password: ThisismyWPA-PSKpre-sharedkey)