Chapter 2 The Web Configurator
VMG4927-B50A / VMG9827-B50A / VMG3927-B50B User’s Guide
38
Remote
Management
MGMT Services Use this screen to enable specific traffic directions for network services.
Trust Domain Use this screen to view a list of public IP addresses which are allowed to
access the VMG through the services configured in the Maintenance >
Remote Management screen.
SNMP SNMP Use this screen to configure SNMP (Simple Network Management
Protocol) settings.
Time Time Use this screen to change your VMG’s time and date.
Email
Notification
Email Notification Use this screen to configure up to two mail servers and sender addresses
on the VMG.
Log Setting Log Setting Use this screen to change your VMG’s log settings.
Firmware
Upgrade
Firmware
Upgrade
Use this screen to upload firmware to your VMG.
Backup/Restore Backup/Restore Use this screen to backup and restore your VMG’s configuration
(settings) or reset the factory default settings.
Reboot Reboot Use this screen to reboot the VMG without turning the power off.
Diagnostic Ping&Traceroute
&Nslookup
Use this screen to identify problems with the DSL connection. You can
use Ping, TraceRoute, or Nslookup to help you identify problems.
802.1ag Use this screen to configure CFM (Connectivity Fault Management) MD
(maintenance domain) and MA (maintenance association), perform
connectivity tests and view test reports.
802.3ah Use this screen to configure link OAM port parameters.
OAM Ping Use this screen to view information to help you identify problems with the
DSL connection.
Table 7 Navigation Panel Summary (continued)
LINK TAB FUNCTION
To Next Page
Loading...
