ENGLISH
5
If the WAN status is Down (or there is not an IP address), click the wizard icon and use
Section 4 to configure the WAN.
3 Bridge Mode
When you set the ZyWALL to bridge mode, it functions as a transparent firewall. Do the
following to set the ZyWALL to bridge mode.
4 Internet Access Setup and Product Registration
1 Click the wizard icon in the HOME screen and then the Internet Access Setup link to
open the Internet access wizard.
1 Click MAINTENANCE in the
navigation panel and then
Device Mode.
2 Select Bridge and configure a
(static) IP address, subnet
mask and gateway IP
address. These apply to the
ZyWALL’s LAN and WAN
interfaces.
3 Click Apply. The ZyWALL
restarts.
To Next Page
Loading...
