ether [rfc|3com] set /display pppoe ether type
proxy disp Display PPPoE proxy client session table
active [on | off] Turn on / off PPPoE proxy function
debug [on | off] Turn on / off PPPoE proxy debug function
time <interval> Set the time out interval, it’s a count. Actual time is count * 5
seconds.
init Initialize PPPoE proxy client session table
flush Clear PPPoE proxy client session table
PPTP Related Command (All commands can only be used in Router Mode) Home
Command Description
pptp
dial <rn-name> dial a remote node
drop <rn-name> drop a remote node call
tunnel <tunnel id> display pptp tunnel information
AUX Related Command (All commands can only be used in Router Mode) Home
Command Description
aux
atring <device name> Command the AT command to the device.
cnt
disp <device name> display aux counter information
clear <device name> clear aux counter information
drop <device name> disconnect
init <device name> initialize aux channel
mstatus <device name> display modem last call status
mtype <device name> display modem type
netstat <device name> prints upper layer packet information
rate <device name> show tx rx rate
redirect <device name> invalid
signal <device name> show aux signal
Configuration Related Command
(All commands can be used in both Router Mode and Bridge Mode) Home
Command Description
config The parameters of config are listed below.
edit firewall active
<yes|no>
Activate or deactivate the saved firewall settings
custom-s
ervice
<entry#>
name
<string>
Configure selected custom-service with name = <string>
ip-protocol <
icmp | tcp |
udp | tcp/udp
|
user-defined
>
Configure IP Protocol Type for selected custom-service
port-range
<start port>
<end port>
When ip-protocol = “tcp | udp | tcp/udp “. configure port
range for custom-service entry #. For single port
configuration, start port equals to end port.
user-defined-
ip
<1~65535>
When ip-protocol = “user-defined”. Configure user
defined IP protocol.
icmp-type
<0~255>
When ip-protocol = “icmp”, configure ICMP type.
To Next Page
Loading...
