ZyXEL Communications ZyWALL 2 Plus - Page 25

reserve [0:no/1:yes] R Reserve UPnP NAT rules in flash after
system bootup.
save R save upnp information
Exit Command Home
Command Flag Description
exit R + B exit smt menu
Device Related Command Home
Command Description
dev
channel
drop <channel_name> R + B drop channel
dial <node#> R + B dial to remote node
Ethernet Related Command Home
Command Flag Description
ether R + B
config R + B display LAN configuration information
driver R + B
cnt R + B
disp <name> R + B display ether driver counters
ioctl <ch_name> R + B Useless in this stage.
status <ch_name> R + B see LAN status
version R + B see ethernet device type
pkttest
disp
packet <level> R + B set ether test packet display level
event <ch> [on|off] R + B turn on/off ether test event display
sap [ch_name] R + B send sap packet
arp <ch_name> <ip-addr> R + B send arp packet to ip-addr
debug
disp <ch_name> R + B display ethernet debug infomation
level <ch_name> <level> R + B set the ethernet debug level
level 0: disable debug log
level 1:enable debug log (default)
edit R + B
load <ether no.> R + B load ether data from spt
mtu <value> R + B set ether data mtu
speed <speed> R + B set ether data speed
save R + B save ether data to spt
dynamicPort
dump U+R+B display the relation between physical port and
channel.
set <port> <type> U+R+B set physical port belongs to which channel.
spt U+R+B display channel setting stored in SPT.
POE Related Command (All commands can only be used in Router Mode) Home
Command Description
poe
status [ch_name] see poe status
dial <node> dial a remote node
drop <node> drop a pppoe call