4. Symptom: PC can't ping remote gateway through VPN tunnel under this special
topology.
Condition:
PC------LAN ZyWALL_A WAN-----------------LAN ZyWALL_B
WAN-------Internet
(192.168.1.33） （192.168.100.33） (192.168.100.1) （172.202.77.145)
(1) VPN configuration in ZyWALL_A:
WAN IP Address=192.168.100.33，WAN IP Subnet Mask=255.255.255.0，
Gateway IP Address=192.168.100.1.
Gateway policy，Name=IKE1，Remote Gateway Address=192.168.100.1，
Pre-Shared Key=12345678.
Network policy for IKE1，Active=enable，Name=IPSec1，Local Network/Starting
IP Address=192.168.1.33，Remote Network/Starting IP Address=0.0.0.0
(2) VPN configuration in ZyWALL_B
WAN IP Address=172.202.77.145，WAN IP Subnet Mask=255.255.0.0，Gateway
IP Address=172.202.77.1.
Gateway policy，Name=IKE1，Remote Gateway Address=192.168.100.33，
Pre-Shared Key=12345678.
Network policy for IKE1，Active=enable，Name=IPSec1，Local Network/Starting
IP Address=0.0.0.0，Remote Network/Starting IP Address=192.168.1.33.
(3) When we established the VPN tunnel between ZyWALL_A and ZyWALL_B,
we can access ZyWALL_B (192.168.100.1) with the remote management,
such as Telnet, FTP…, this traffic will go through VPN tunnel. However, we can
not ping ZyWALL_B (192.168.100.1) successfully because this ICMP traffic
did not go through VPN tunnel to ZyWALL_B.
[CNM]
1. DES/3DES encryption key doesn’t unique.
2. The 2 check boxes “Log” and “Block” of Matched Web Pages can’t be disabled
on Content Filter/ Categories page when Schedule to Block has set time interval
on Content Filter/General page.
3. Vantage GUI misses to show the NetBIOS port, 445 in Firewall “W2L_Rule_2”
default rule.
4. [Symptom] Device will crash, when Vantage set Dial Back Fixed IP in the same
subnet with WAN to device.
[Condition]
(1). Let device register to Vantage.
(2). Vantage set Dial Backup to enable.
(3). Vantage set Dial Backup Fixed IP in the same subnet as WAN to device.
(4). Device will crash after writing above settings.
5. Change NAT mode from “SUA” to “Full Feature”, device will create 2 address
mapping rules automatically but Vantage Server will not.
6. Vantage and Agent are not consistent at VPN/IPSec/Protocol field. Vantage is a
dropdown list with “Any”, “ICMP”, “TCP”, “UDP” selections and Agent is a
0~999 value range.
7. Vantage and Agent are not consistent at Firewall rule’s log. Vantage has 4
selections “None”, “Match”, “Not-Match”, “Both”. Agent has only a check box.
8. Firewall Default Action can’t select “Permit”, “Drop” and “Reject” via Vantage.
9. Firewall name can’t display on Firewall page on Vantage GUI.
To Next Page
Loading...
