ZyWALL 5 Internet Security Appliance
3
LABEL DESCRIPTION
EXTENSION
CARD SLOT
Turn off the ZyWALL before inserting or removing an 802.11b/g-compliant wireless
LAN PCMCIA or CardBus card (to avoid damage).
POWER Connect the included power adaptor (use only this adaptor) to this power socket.
1.3 Setting Up Your ZyWALL
The example figures in this section are for a ZyWALL in router mode. The ZyWALL is set to router
mode by default. To have the ZyWALL function as a bridge, select Bridge and click Apply in the
MAINTENANCE Device Mode screen.
1. Router Mode: Connect your cable/DSL modem to WAN port with the Ethernet cable that came
with your modem.
Bridge Mode: Connect a router to WAN port with an Ethernet cable..
2. Router Mode: Connect computers or switches to LAN ports with Ethernet cables.
If you configure these ports as DMZ ports in the LAN or DMZ screen through the Web
configurator, connect publicly accessible servers (Web, FTP, etc.) to these ports to make the
servers visible to the outside world.
Bridge Mode: Connect computers or switches to LAN/DMZ ports with Ethernet cables.
1.
2.
To Next Page
Loading...
