ZyWALL 5 Support Notes
All contents copyright (c) 2006 ZyXEL Communications Corporation.
249
Step 3. Input the MAC address of LAN interface of the device. Give this device a name. Select the
corresponding Device Type, press Finish.
Note that if the ZyWALL has been deployed (configured) and you want to retrieve the configuration from
device. You can select the option “Get configuration from the device”. Otherwise, you can use “Set
Vantage CNM configuration to device” to overwrite existing configuration on device as soon as it
registers to Vantage CNM.
After finishing the configuration on Vantage CNM, click on “Finish” to finish the registration of device
on CNM and following screen will show up and ZyWALL is added to CNM under folder AAA.
Step 4. On the device, go to ADVANCED->REMOTE MGMT->CNM, enable Vantage CNM and
configure Vantage CNM Server Address in the filed. If Encryption Algorithm is enabled, you must select
the same algorithm and secret key on both device and Vantage CNM. In the following case, the
Encryption Algorithm is disabled.
To Next Page
Loading...
